The Entry Keypad is the primary controller for your home security system. It should be placed by an entrance in your home like your front door or garage door and can be mounted on the wall or set on a tabletop. Ideally the keypad is plugged into an outlet for the best experience, but it can be used with only batteries if you do not have access to a power outlet.
INSTALLING THE ENTRY KEYPAD INCLUDED WITH YOUR KIT
After the base has been set up, open the box labeled “Step 2” and remove the device. Follow these steps to complete the device set-up:
Remove the back by lifting on the snap
Pull out the plastic battery tabs, making sure the batteries remain in place
Recommended, but Optional: Plug the power cord into the back of the Entry Keypad
Replace the back cover on the keypad by inserting top tabs before snapping the cover back into place.
INSTALLING ACCESSORY ORDER ENTRY KEYPADS
If you have purchased a keypad after initial install you may have to pair the device with your Base. To do this, pull the battery tab as outlined above. Go to Settings > Devices > Security Devices > and select Keypad. Follow the instructions on the application to pair the device. When the device is paired the base will play a confirmation sound to indicate the keypad has been successfully activated.
PLACING THE ENTRY KEYPAD
You have two options for mounting your Entry Keypad.
On the Wall: Secure the Entry Keypad to the wall by using the mounting bracket included.
On the Table: Secure the table stand to the Entry Keypad.
Snap the table stand onto the back plate by inserting the top tabs of the table stand into the plate.
Apply pressure to the bottom tabs until they can be inserted.
After your Entry Keypad is set in place, plug the power cord into your power outlet as well as the back of the keypad
Note: Keep Entry Keypad within 30 feet of your Base for best signal range.
KEYPAD SETTINGS
Chime Enabled: Enables/disables the keypad playing chime tones when a sensor is faulted and chimes are enabled for that sensor
Panic Enabled: Enables/disables the panic alarm feature on the keypad. Click here to learn more about Panic alarms: Panic and Duress
Entry Tone Enabled: Enables/disables the entry countdown tones to play through the keypad when a sensor is faulted and starts the entry delay
Exit Away Tone Enabled: Enables/disables the exit countdown tone on the keypad when the system is going into away mode
Exit Stay Tone Enabled: Enables/disables the exit countdown tone on the keypad when the system is going into stay mode
Siren Enabled: Enables/disables the siren when an alarm goes off
